Engineering
Engineering, 12.11.2019 04:31, PKTHUNDER5011

Ashaft is loaded in bending and torsion such that ma = 70 n. m, ta=45 n. m, mm=55 n. m, and tm = 35 n. m. for the shaft, su = 700 mpa and sy=560 mpa, and a fully corrected endurance limit of se=210 mpa is assumed. let kf=2.2 and kfs=1.8. with a design factor of 2.0 determine the minimum acceptable diameter of the shaft using the (a) de-gerber criterion. (b) de-asme elliptic criterion. (c) de-soderberg criterion. (d) de-goodman criterion. discuss and compare the results.

answer
Answers: 2
Get

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, jadeochoa4466
The temperature of air decreases as it is compressed by an adiabatic compressor. a)- true b)- false
Answers: 2
image
Engineering, 04.07.2019 18:10, winterblanco
The higher the astm grain-size number, the coarser the grain is. a)-true b)-false
Answers: 3
image
Engineering, 04.07.2019 18:10, Candi9697
A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.
Answers: 2
image
Engineering, 04.07.2019 19:10, moneyyfletcher
The air in an automobile tire with a volume of 0.015 m3 is at 32°c and 140 kpa gage. determine the amount of air that must be added to raise the pressure to the recommended value of 206 kpa gage. assume the atmospheric pressure to be 128 kpa and the temperature and the volume to remain constant.[r-0.287 kj/kgk]
Answers: 3
Do you know the correct answer?
Ashaft is loaded in bending and torsion such that ma = 70 n. m, ta=45 n. m, mm=55 n. m, and tm = 35...

Questions in other subjects:

Total solved problems on the site: 7691626