Engineering
Engineering, 12.11.2019 04:31, boweytom6217

Athree-point transverse bending test is conducted on a cylindrical specimen of aluminum oxide having a reported flexural strength of 390 mpa (56,600 psi). if the specimen radius is 2.5 mm (0.10 in.) and the support point separation distance is 30 mm (1.2 predict whether or not you would expect the specimen to fracture when a load of 620 n (140 lbf) is applied. calculate the value of flexural strength for this test.

answer
Answers: 1
Get

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 15:10, EmilySerna
Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.
Answers: 1
image
Engineering, 04.07.2019 18:10, ahmedeldyame
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
image
Engineering, 04.07.2019 18:10, tjeffers90028
Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.
Answers: 1
image
Engineering, 04.07.2019 18:10, winterblanco
The higher the astm grain-size number, the coarser the grain is. a)-true b)-false
Answers: 3
Do you know the correct answer?
Athree-point transverse bending test is conducted on a cylindrical specimen of aluminum oxide having...

Questions in other subjects:

Konu
Arts, 09.10.2019 08:30
Konu
Chemistry, 09.10.2019 08:30
Total solved problems on the site: 10222922